When using an ice machine, proper installation and setup are crucial to not only ensure the efficient operation of the machine, but also to extend its service life. Here are some key considerations to read and understand carefully before using your ice machine:

Ice-making machine user manual – Additional notices
1, Ice-making machine placement
⑴ Machine should be placed in the air circulation, surrounded by a safe and clean place. 
⑵ Machine should not be placed in the open air, should not be exposed to direct sunlight and rain.
⑶ Do not place near the heat source. The use environment of machine can not be less than 5 ℃, not higher than 40 ℃. 
⑷ The machine should have enough space for four weeks, especially the rear should not be less than 150mm for the machine to dissipate heat.
⑸ Please adjust the base screws at the bottom of the machine to keep the machine level stable.

2. Installation of water system
⑴ Please connect the water source that meets the local drinking water standard.
⑵ Use a filter if need to improve the drinking standard of water.
⑶ The water supply system must meet the following conditions:
a, the water temperature minimum 2 ℃, the highest not more than 35 ℃
b, the minimum pressure of 0.02Mpa, the highest 0.8MPA

3, Power supply installation
⑴ The power supply must be the same as that indicated on the machine nameplate.
⑵ All lines must conform to national standards.
⑶ Must be grounded reliably, grounding wires must conform to electrical standards.
⑷ Voltage fluctuation shall not exceed the ±10% of the rated voltage.

In short, the environment and location where the ice machine is placed are crucial, and the correct installation of the water system and power supply are also essential. By following the above precautions, you can ensure the safe operation and efficient working of your ice machine, extend its service life, and provide quality ice service.