+86-512-52430899 csshdq@csshdq.com
Contact Us

Contact Information

  • Address: Shanghu Town, Wangzhuang Jiaxin Industrial Area Changshu City, Jiangsu Province China
  • Tel: +86-512-52430899
  • Fax: +86-512-52438870
  • E-mail: csshdq@csshdq.com
Home > Exhibition > Content
Ice making process
May 23, 2017

(1) before the boot must check the automatic water supply device is normal, the water tank is reasonable water (the machine has been adjusted when the factory water level, the user may not make correction).

(2) plug in the power supply, the ice machine began to work, first the pump began to run (the pump has a short time the air process) about 2 minutes after the compressor starts, the machine into the ice state.

(3) When the ice thickness reaches the set thickness, the ice plate starts to start, the solenoid valve starts to work, the pump stops working, the hot air enters the evaporator, and the ice falls about 1.5 minutes. When the ice falls, turn the ice fall and turn on the reed switch. When the reed switch is closed, the machine enters the ice making process again.

(4) Compressors are not stopped throughout ice making and deicing.

(5) When the ice bucket inside the ice, the reed switch can not automatically close, the machine automatically stops working, when taking enough ice, reed switch re-closed, the delay after 3 minutes the machine starts, re-entry system Ice process.

Previous: No Information

Next: Installation of water system