+86-512-52430899 csshdq@csshdq.com
Categories
Contact Us

Contact Information

  • Address: Shanghu Town, Wangzhuang Jiaxin Industrial Area Changshu City, Jiangsu Province China
  • Tel: +86-512-52430899
  • Fax: +86-512-52438870
  • E-mail: csshdq@csshdq.com
News
Home > News > Content
Precautions For The Use Of Laboratory Ice-making Machines
Oct 25, 2017

1, the ice-making machine should be installed in a far away from the heat source, no direct solar irradiation, good ventilation, the ambient temperature should not exceed 35 degrees Celsius to prevent the environment temperature too high caused by the condenser heat dissipation, affecting the ice-making effect. Also be careful not to place in the North Room or the north side of the ventilation, in order to prevent the northern winter temperature is too low, resulting in ice, the general ice temperature control at more than 7 degrees, so that when the ambient temperature is below 7 degrees, ice-free, show and full of prompts, to draw users do not be nervous, no problem, belong to the normal phenomenon, The ground of the ice-making machine should be solid and smooth, the ice-making machine must be kept level, otherwise it will result in no ice removal and noise during operation.

2, the ice-making machine back and left side gap should not less than 30cm, the top clearance should not less than 60cm the machine heat transfer is better.

3, ice-making machine should use independent power supply, dedicated line and equipped with fuse and leakage protection switch, and to reliable grounding.

4, ice-making machine to meet the national drinking water standards, and add water filtration devices, filter impurities in the water, so as to avoid clogging water pipes, pollution sinks and ice molds. and affect the performance of ice-making.

5, cleaning the ice-making machine should be turned off the power, strictly prohibited with the water pipe directly to the fuselage flushing, the application of neutral detergent scrub, is strictly prohibited with acidic, alkaline and other corrosive solvent cleaning.

6, the ice-making machine must be two months to open the water hose pipe head, cleaning the water valve strainer, to avoid the sand in the mud impurities blocking the inlet, and causing the inflow of water to become smaller, resulting in no ice.

7, ice-making machine must be cleaned every two months condenser surface dust, condensation heat dissipation will cause compressor parts damage. Cleaning, use vacuum cleaners, brush, such as washing condensation surface oil dust, can not use sharp metal tools to clean up, lest damage the condenser.

8, ice-making machine water pipes, sinks, storage refrigerators and protective film to be cleaned every two months.

9, ice-making machine is not used, should be clean, and with the hair dryer blow dry ice mold and box moisture, in non-corrosive gas and ventilated dry place, to avoid open storage.

10, the production of ice confidential place in the acid corrosion gas production, special copper tube, radiator aluminum products belong to the lively type of metal, generally susceptible to acidic atmosphere corrosion. Acidic corrosive gas is also serious to the corrosion of electrical devices, which can cause bad contact and affect the normal operation of the control system. The influence of acidic corrosive gases on polymer materials is also very large, especially ABS materials.

11, ice-making machine tap water to take over the joint, hope to connect reliable and stable, in order to prevent the connection unreliable, when there is no time to spray water, affect the surrounding environment and ice-making machine safety, hope to regularly replace the pipe joints to ensure reliable.


[[JS_BodyEnd]]